Honda Accord 2012 gebraucht - AutoUncle (2024)

FAQs

How do I reset my Honda Accord collision mitigation system? ›

Press and hold the CMBS™ OFF button. A beep sounds and a message appears in the Driver Information Interface. The CMBS™ indicator appears when the system is off. CMBS™ automatically resets back to ON each time you start the engine.

The 2012 Honda Accord has its share of issues, including eight airbag recalls, uncomfortable driver seats, and excess oil use, but these issues are being reported in low enough numbers that it's pretty safe to say this is one of the better used vehicles in its size class today.

Diagnostic trouble code (DTC) P0302 stands for “Cylinder 2 Misfire Detected.” The code is triggered once your ride's PCM detects frequent misfires on cylinder 2. A P0302 code can be caused by a bad fuel injector or a malfunctioning injector circuit. A failed coil pack or worn spark plug can also trigger the code.

When the CMBS is on, the radar sensor constantly scans for vehicles ahead of you. This means that driving on a road with a few or no vehicles could cause a CHECK CMBS RADAR SENSOR message to appear on the multi-information display. This is normal and not a cause for concern.

The CMBS utilizes a radar sensor in the grille and a front-facing camera located behind the rearview mirror to help detect other vehicles and pedestrians on the road ahead.

A Honda Accord should be able to last an average of about 250,000 miles, but this number can change dramatically depending on how well it is maintained over the course of many years.

Overall, we still think the 2012 Honda Accord is a good pick for a family sedan. But we certainly suggest shopping the competition before settling for this Honda icon.

The 2013–2012 Honda Accord has brake caliper issues, which are known for causing vibration and grinding noises at all times. The brake rotor is a disk that sits between two brake pads. The brake pads are squeezed against the disk by what is called a brake caliper.

Prices for a used 2012 Honda Accord currently range from $3,900 to $15,995, with vehicle mileage ranging from 25,445 to 229,032.

What is high mileage for a Honda Accord? ›

How long do Honda Accords last? According to getjerry.com, a Honda Accord is anticipated to last between 200,000-300,000 miles. If you take proper care of your Honda Accord, it may stretch long past that milestone before experiencing a need for severe repairs.

A: As per the guide, the most reliable Honda Accords are the 2006 and 2007 models from the seventh generation and the 2011 and 2012 models from the eighth generation. These specific years have garnered positive feedback for their dependability and have fewer reported issues compared to other years.

If the cylinder does not function correctly for long enough, it may have trouble functioning once the issue is resolved. Additionally, the common causes for this problem can cause other problems which may render your engine completely broken. You should never ignore a P0302 error code.

The longer you ignore the problem and drive the vehicle in spite of the misfire, the more likely it is that your engine will suffer serious damage. A misfire on its own does not usually signal a serious mechanical problem. Very often, it is just a spark plug, ignition coil or a fuel injector that needs to be replaced.

The cost of repair and replacement can range from anywhere between $100 to $1000, depending on the reason for the misfire. The most common causes of misfire and their average estimated cost of repairs are listed below: Poor fuel delivery: $200-$1,000. Faulty spark plug wires: $100-$300.

For example, if you want to turn off RDM, you can press a button under ECON, and LKAS can be turned off by pushing the MAIN button on the steering wheel until the indicators in the instrument cluster are gone. Pressing the MAIN button again will reset Honda Sensing®.

If you want to turn off CMBS just press and hold down the CMBS button located to the left of the steering column until you hear a beep and a confirmation message displays in the vehicle's Driver Information Interface. CMBS will now be shut down until you turn off the ignition.

Make sure all of the doors on your vehicle are fully closed and locked. Using the buttons on the key fob, press the panic button. Continue holding the panic button down until the horn honks once, which indicates that the system has been reset.